Manly Card - Vest for Dad - .svg and .mtc files for use with Cricut

Hello. I was looking back through my huge stack of "ideas" and ran across a project that I had been working on a while back.  I decided to finish it up and put it out here to share with the Cricut and blogging world.  I found the original pattern in a February 2008 edition of Paper Crafts magazine (page 60) entitled Vest Card. You can find the magazine's website at  http://www.papercraftsmag.com/index.html. (Unfortunately, the website no longer goes back to that edition!)  The article notes that the design was courtesy of Tinkering Ink & Mainly Stamps.  I believe Tinkering Ink's website address is: http://www.tinkeringink.com/ (but I didn't find anything there related to this Vest Card.)  I have seen other "vest" cards in the past, but this is where I got my pattern from.

First, I copied and cut out the pattern provided in the magazine.  I then enlarged it and scanned it.  I usually scan it in and save it in a graphics format like .jpeg or .png and then import that into Inkscape to get an .svg file.  I then take the .svg file and import it into either Make the Cut ("MTC") or Sure Cuts A Lot (SCAL). 

There really aren't any "directions" to prvide. Once you cut out the card from a patterned cardstock, you simply fold the card at the middle of the arm holes so that the points of the bottom of the vest line up.  The "flat" side of the vest (as opposed to the pointed side) is the outside overlapping flap.  The .svg file does not have the "pocket" and the "hankie".  I created those and imported them directly into MTC from the scanner.  Glue the "hankie" to the backside of the "pocket" and then glue the pocket onto the front left side of the Vest.  You can then create "buttons" or add real buttons to the right front side of the Vest.  I created buttons with a small hole punch and glued them onto the card front. Then used a marker to make button holes.

You can download the Vest Card .svg file here.  If you have the latest version of the Make the Cut (MTC) software (not the beta 2.x version) you can download the Vest Card .mtc file here.  The MTC file is sized correctly and has the pocket and the hankie cuts as well. As always, let me know if you have any problems with any of my files and I would love to see what you create with any of them!  Thanks for stopping by.